Inspection

Cedar Siding Pre-Building Recommendations

Material Inspection

Always purchase recognized grades such as those from WRCLA members and ensure you understand the grade of material you’ve purchased. Grades are designed for specific appearances and uses. Before installing, be sure the siding you’ve selected meets your requirements. Any product found to be damaged or visually unacceptable for any reason should not be installed; if you encounter any such product STOP and call your supplier immediately.

Acclimatize

How to Acclimatize Siding

Cedar Siding on House ThumbnailOne of the most stable softwoods, Western Red Cedar is nevertheless a natural material and it responds to the environment. Cedar siding can swell or shrink as it gains or loses moisture to reach equilibrium with the moisture content of the surrounding air. Ensuring that the moisture content of cedar siding is at equilibrium before it is installed will minimize movement later on. Recommended moisture content for sidings used in various regions of the country are given in the table below. On the job site, keep the wood dry. Stack siding off the ground and under cover. If the wood is to be stored over damp ground or new concrete, place a moisture barrier under the siding. Siding should be 4″ to 6″ (102-152mm) above the ground with air circulating freely around and throughout the stack. Acclimatization time varies with the moisture content of the siding. The following procedures are suggested for different siding specifications.

Job Site Storage

Cedar Siding Storage and AcclimationUntil installed, Western Red Cedar siding needs protection from direct sunlight, water saturation, snow, ice, dirt, and other elements. Store the siding flat and off the ground on stickers and a vapor barrier so that moisture is not absorbed through the bottom boards of the stack. Protect with a waterproof covering elevated in the center so that water does not pool on the cover. Do not completely seal the bundle, as good air circulation is required. Ideally, the siding should be stored in an enclosed building such as a garage prior to use.

Kiln Dried Clears Outdoor covered cedar decking

These have been dried at the mill to 12-15% moisture content. They are the most ready-to-use of all siding products. If the siding has not been wetted prior to arrival on the job site it may be applied upon arrival except in the Southwest where 3 to 5 days of well ventilated storage is generally required. If the siding has been wetted it must be separated and allowed to dry thoroughly before installing.

Dry Knotty Sidings

Knotty sidings are air or kiln dried to less than 19% moisture content. Stack the siding on evenly spaced, vertically aligned stickers (figure below) in a dry storage area for 7-10 days. More time may be required in damp or humid conditions.

Green (Unseasoned) Sidings Drying and Acclimating Cedar Before Use

Unseasoned or green sidings have not been dried prior to delivery and require a longer time to acclimatize than seasoned sidings. Separate the siding with vertically aligned stickers (figure on right) and store in a well ventilated dry location for a minimum of 30 days or longer in damp or humid conditions. If specifying unseasoned siding, patterns such as channel, bevel and board-and-batten are recommended since these allow for shrinkage. Narrower widths are also recommended since these move less overall than wider widths. Recommended Moisture Content for Siding Installation

Most AreasDry, Southwest StatesDamp, Warm Southeastern Coastal Areas
AverageIndividual PiecesAverageIndividual PiecesAverageIndividual Pieces
12%9 – 14%9%7 – 12%12%9 – 14%
  1. To calculate average, test 10% or more of pieces.
  2. Source: Wood Handbook 1987.